Wheat-Sow Humpback Beetle: In selectors with liquid spraying system, the ideal amount of water is found with a preliminary test (This amount varies between 500-800 ml for 100 kg of seed). After this is determined, the required amount of drug is put into the required amount of water and the spraying is done. If the spraying will be done with a spraying barrel (cascade), the recommended amount of drug for 100 kg of seed is added to 800-1000 ml of water. It is waited for it to settle to the bottom, then it is mixed well. It is added to the spraying barrel several times, turning the barrel each time to ensure a homogeneous spraying. Corn-Wireworms: The recommended drug for 100 kg of seed is added to 1.5 liters of water and mixed well, half of it is added to the seed on the nylon spread on a flat surface and mixed, then the other half is added and mixed well again. The same process is valid for the spraying barrel (cascade) and spraying canisters. After spraying, the seeds are spread out and ventilated. After the humidity is reduced, it can be planted immediately or stored until planting time. If stored in a humid environment, the germination power of corn seeds decreases due to humidity.
Potato-Potato Beetle: Seed potatoes are spread on a flat surface. The recommended amount of drug for 100 kg of seeds is added to 1-1.5 L of water in a bucket, mixed well and transferred to the pulverizer. After half of the mixture prepared is sprayed on the seed potatoes, the potatoes are turned upside down with a shovel. Then, the remaining half of the drug is sprayed and the spraying is completed. The point to be considered during spraying is that the amount of water should be enough to wet the seed but not run off. Planting can be done immediately after spraying, or after the moisture of the seeds has dried, they can be bagged or left in bulk for a few days. Protective gloves should be worn during spraying, bagging and planting.
Potato-Wireworms: Seed potatoes are spread on a flat surface. The recommended amount of medicine for 100 kg of seeds is added to 1-1.5 L of water in a bucket, mixed well and transferred to the pulverizer. After spraying half of the prepared mixture on the seed potatoes, the potatoes are turned upside down with a shovel. Then, the remaining half of the medicine is sprayed and the spraying is completed. The point to be considered during spraying is that the amount of water should be enough to wet the seed but not run off. Planting can be done immediately after spraying, or after the moisture of the seeds dries, they can be bagged or waited for a few days in bulk. Protective gloves should be worn during spraying, bagging and planting. Sugar Beet - Underground Pests: Due to the sensitivity of sugar beet seeds to moisture, the volume of the medicine mixture to be applied in seed processing and spraying factories with professional spraying systems in order to perform a precise spraying depends on the type of equipment, other substances entering the mixture and drying machines. Therefore, follow the instructions for the existing spraying equipment. The amount of water required for spraying to be done with spraying barrels and similar equipment is 15-20 liters. The required amount of medicine for 100 kg of seeds is added to 15-20 L of water and waited for it to settle to the bottom, then mixed well and made ready for spraying. This amount of medicine solution is applied to the seeds in 3 times, mixing each time to ensure good coating.